ஜாக்கெட் தைப்பதற்க்கு அளவு எடுப்பது எப்படி

ஜாக்கெட் தைப்பதற்க்கு அளவு எடுப்பது எப்படி
 

1. Height 

Height Measurement should be taken from the Customer’s Back Side directly in their Body. First we should, Correct the Customer’s Blouse without any wrinkles, Start taking the Measurement from the Shoulder Down to their Hip, While taking the Height Measurement, we should not leave any extra for Folding or Stitching seam, only finishing measurement should be taken from Customers

2. Body Loose(Second)

Second Body Loose Measurement should be taken from the Customer Chest Round. No Loose should be leaven. We need the Accurate Finishing Loose. Avoid Measurements like 0.25”, 0.5”, and 0.75”. Ex: 38”.

3. Shoulder Finishing 

Shoulder Finishing is not meant by full Shoulder Measurement, it should be taken from Sleeve joint Portion (Shoulder Bone) towards Neck Side, depends on the Customer requirement about the narrow or Wide Neck. According to their Body loose. It will be 2 0r 2.5” Ex: 2.5” 

4. Hand Height 

Hand Height Measurement should be taken from the Shoulder Finishing End portion towards Down to the Customer required Height. The Measurement is only for Sleeve Height should not leave for any folding or Stitching. Ex: 9 .5”. 

5. Sleeve Loose 

Sleeve Loose Measurement should be taken from where we taken the End of Sleeve Height, in the same part Sleeve Loose should be taken. Tape should not be Free or Tight. Measurements taking should not be in 0.25, 0.75 like 14.25 or 13.75. It may be in 0.5, like 12.5, 13,13.5, 14, 14.5,.. Ex: 11.5”. 

6. Middle Hand Loose 

Middle Hand Loose Measurement should be taken in the Under Arm Position Circumference. Tape should keep in the Under Arm of the Customer and set their hands in normal Downward Position, now measure their Middle Hand Circumference without any Tight or Loose. Ex: 12”.

7. Front Neck Height

Front Neck Height Measurement should be taken from the Front Shoulder Center towards Down. The Measurement should be 0.5” - 1” excess of the Customer Body Armhole Line. Tape should not be place Cross, it should be Placed straight. Ex: 6”.

8. Back Neck Height

Back Neck Height Measurement should be taken from the Back Shoulder Center towards Down. The Measurement should be 0.5” - 1” excess of the Customer Front Neck Height. Tape should not be taken Cross, it should take straight. Ex: 6.5”.

9. Total Waist Loose

Total Hip Loose (waist) Measurement should be taken from the Customer Hip Side where they wear Blouse Last Hook; This tight should be as their Feel to lock the Blouse Hook on Wearing. It should not be in Numbers like 25.5”, 28.5”(.5 Measurements) It must be a whole Number like 26, 27, 28,…. Note: While taking this Measurement the Customer will not allow to tight their Hip Loose but you never mind. This Measurement should be always tight, then only fitting will be Perfect. Ex: 32”

10. Front Point Center 

Front Point Center Measurement should be taken from the Customer Front Side from Center of the Shoulder towards Down till their Cup Size (Body Loose Part). This Measurement should be Accurate. It should not be in Numbers 9.75” , 10.25 ”,… It must be a Numbers like 9.5, 10,10.5,…. Note: Don’t allow the Customer to Bend Down, they should be stand straight. Ex: 9.5”.